"My friend" ;) used this methode to brake in into a computer store. It i9s relativly easy. You need:
Batery drill
Aligator clips
A paralizer rated at 200KV or hihger
A 9 volt alkaline batery.
Find two wires that lead to the alarm system, this can be the alarm strobe or siren. Never open the box with a screwdriver as a sabotage contact may send a signal to the unit. Instead drill a hole into the box and pull some wires out. Connect one end of the aligator clips to the paralizer while the other end to the wires that provide power to the siren or strobe, making sure nut to cut true the cable (incesion with an exacto knife will do). No worrys as there is no power on the wires (otherwise the sire would allready go) Press the trigger for 10 seconds while Hihg voltage is going from the power cables back to the processor unit. Sparks will jump over sensitive micro procerssors, destroying everything in its path. Best results are achieved by insulating the contacts of the paralizer, forcing thereby the high voltage to discharge inside the alarm systems circuit. After applaying some fun to the system, you can check for safe status by cutting treu the sabotage contact. Wait for 30 minutes (safe distance) as it maight be a silent alarm triggering. After this you may asume safe status and entering the building. Always carry respirator and one or two super value plus containers teargas with you, as you might need this to come out in case of emergency.
No comments:
Post a Comment